Excellent.

I found the easiest way to load it onto a trailer was to start with it on a trailer, and put the two tail to tail. We just pushed her from one to the ...

That looks rapid!

Interesting. I've also read about folks having a sensor of some sort which only reads a low level (on/off), rather than the levels as it drops. Appare...

Hi John, thanks for your reply.Yes, that's my understanding too. I'll connect the IG terminal to the '+' 12V wire for now, until new information shows...

As suspected, one of the pins required a little squeeze - I had noticed when the wires on the back of the connector were moved, the values changed on ...

I think one of the pins on the connector for the pressure sensor needs replaced, or given a little squeeze, I'll hopefully get that sorted soon. Yes, ...

It turns out that the the Geartronics unit had some water ingress and has now been repaired. I must say that there was a quick turnaround from Neil @ ...

There's some info on the Geartronics site about this:

He's right on the money - the car is an early SR8 (Gen 2), so has the Geartronics system. Were going to swap the sensors around and plug into the Gear...

There are three wires going to the sensor/switch. Live (12v) , earth and a yellow wire. I measured the voltage on the yellow wire as the pressure incr...

Hi John, Thanks for your reply. A known working sensor may help to solve this. What is confusing me is I've checked continuity between the switching p...