Liked Forum Posts
|
RE: Track videos Here are highlights from last Sunday's race. I got a little too close to the Porsche in the first corner and locked up. I finally made up the places at the end! Enjoy! |
In forum Track / Race Videos |
5 years ago |
|
RE: Oil Pre Heater, anyone using one? It's a must. Had Stradale install one when they did my engine this winter. It's the external one held on by adhesive. Was thinking about picking one up and installing myself but it was inexpensive ... |
In forum General Discussion |
5 years ago |
|
RE: Tire options and information I can only comment on the Hankooks. Let me qualify my comments. I am racing and "trying" to be competitive and run up front. On new tires I found it takes 2 or 3 laps for the tires to heat up and r... |
5 years ago | |
|
RE: SR1 How to - add brake pressure sensor Earls hose part numbers977513ERL double banjo bolt 600403ERL hose end, banjo 610003ERL (hose) 600103ERL hose end, AN3 SS981603ERL 1/8npt to AN3 adaptor * SS991001ERL 1/8npt coupler * 1000 psi transduc... |
5 years ago | |
|
RE: SR1 How to - add brake pressure sensor It is possible, I did it. Plus I added a steering sensor. Let me gather the parts list as for the CAN bus, yes it’s there. Otherwise you wouldn’t see engine RPM. |
5 years ago | |
|
RE: Has anyone seen a shifting problem like this? I'm back in business! It turns out there is a shop in East Troy, WI called Gemini Technologies that used to run Michael Jordan's Suzuki motorcycle race team. And they're less than an hour from my hous... |
In forum SR3 Specific Discussions |
5 years ago |
|
RE: Correct shifter direction? (Prosport, Kawasaki) Attachment : temp_rad_lever.jpg |
5 years ago | |
|
RE: Normal running temperatures Always preheat my car to 50c before going out, usually that means the water is somewhere around 70c, and unless it is a very cold day 2 laps bring the temperatures up to where they need to be. If buyi... |
In forum SR3 Specific Discussions |
5 years ago |
|
RE: Trouble shifting out of neutral After the above also make sure the clutch button on your steering wheel is working. If you are having trouble lift the clutch pedal and press it again, this can sometimes help. |
In forum How To / DIY Discussions |
5 years ago |
|
RE: Pop quiz.... That is a Gen 2 OEM Suzuki ECU. Also looks like Gen 2 OEM throttle bodies. I would guess that someone has updated the car to a Gen 2 engine, ECU and loom. I would be slightly worried that it is a road... |
In forum Getting Started |
5 years ago |
|
RE: Correct shifter direction? (Prosport, Kawasaki) @dunc - that's what I understood you to mean. My Prosport is the opposite; back for 1st, forward to go up a gear - same as Charley's observation. On the bike, the gear lever pivots behind the rider's ... |
5 years ago | |
|
RE: Track videos Hi guys! Sharing a video from round #5 of Radical Cup Scandinavia. Pretty intense race with 0,5 seconds separating the two cars for 14 laps. There is a spoiler at 15 minutes 40 seconds if anyone wants... |
In forum Track / Race Videos |
5 years ago |
|
RE: Fuel choices @tommymills, 100LL is formulated to burn best at higher altitudes and lower RPMs 1500-3000. |
In forum SR8 Specific Discussion |
5 years ago |
|
RE: Fuel pump seal This is finally resolved. I thought I'd post what I learned in case any other mechanically inept soul gets stuck doing this. 1. Get two new seals instead of one. Inevitably the first will fold over. I... |
In forum General Discussion |
5 years ago |
|
RE: Prosport battery tie-down? And fixed. Bend the tabs, apply Harley battery strap. Next, what's this pixie dust in my oil? 8( |
5 years ago |