CharleyH .

Posted by: @charleyhradicalsportscarregistry-com Danyel Torres Delgado from Wisko Racing / Radical Virginia just posted this picture of the new Steering wheel in the SR3XX. That looks like quite an ...

Hey Tommy! You can certainly upgrade to the SCHD GP 2.2. Without knowing what system in your car, it's hard to know exactly what you need, but it might be as easy as just changing out the recorder, ca...

You can run 2 cameras on one system, but what is shown would not work. The system would use the exp plug on the binder 712 connector from the dash to a 4 port data hub The you would plug each recorde...

@charleyhradicalsportscarregistry-com Thanks for the pics; I was considering that, but hoping I could get the battery tray out to do something a bit more elegant on the bench. Sadly, no such luck, it'...

Oiling the chain only takes a couple of minutes, really easy. If you are concerned about it you could fit an automatic chain oiler. You'll find them on most motorcycle sites, real cheap. They are just...

Both my clubsport (was) and PR6 (is) like that - pull back for higher gears. It can be reversed but it makes much more sense to pull when acceleration is pushing you backwards then push when braking...

My clubsport just used cable ties over the top to keep the battery in place (which I believe was quite common on the early stuff). My PR6 uses the rubber strap as shown above, it goes directly over ...

Dear Josh @meatman Welcome!! I am the one who posted and installed the gear indicator. It was straight forward and great add. You can call me if it is easier 646-354-8780.

Posted by: @tommymills Tage...super newb here in terms of SR3 knowledge. What is the advantage/disadvantage of the 3 piece wheels? The current spec wheel is the one piece. With a 3pc wheel you can ...

@meatman Hi Josh, congratulations on your SR3 purchase and welcome to the forum. Here is a recent post about adding a gear indicator: In regards to the reverse cable, couple of options, there are a f...

Using the idea from @rjbender, but use a strip of thin clear plastic cut from a sheet protector pouch. Use it kind of like a funnel to keep the seal from catching the lip. Lots of lubricant and go slo...

@gwt561324 - get some Teflon plumbing tape and wrap it around the lip of the seal. You might need more than 1 turn/wrap as you will need to get the Teflon tape to stick to itself well enough to hold ...

If wd40 doesn’t work try either dropping it in a pan of boiling water or using a heat gun to shrink the seal slightly

Replied 😀

Looks like we have a few Radicals racing at Brainerd this weekend? If anyone hasn't been there before it's a really fun track. More technical than it appears. With a Radical we should be able to hi...