CharleyH .

@GraemeD that was my plan until I score an Intech 24' enclosed trailer.

@gobble, Hi! My Gen1 SR3 won’t show oil temp until it reaches 45 Centigrade. It’s blank at first and then is intermittent flashing 45 irregularly until the temp is above 45 and then it stays solid and...

@noble819 Not sure how we'd get this to you (I'm in California), or whether it's too not-perfect, but I don't see myself using / fixing this one anytime soon. Attachment : IMG_2937.jpeg Attac...

Following up on my own post; still not clear on whether the end is meant to be angled, but I did find that one of the sleeves was seized in the bushing, possibly due to being over-torqued. After pres...

Mine does have the clutch pedal stop. It doesn't seem to allow a whole lot of clutch pedal travel, but apparently it is enough to operate the clutch.

Interesting they call the red Ferrari Red. I have a Rossa Corsa touch up pen here I bought a few years ago. I'll have to check the match tomorrow.

Hey Nikki, fair enough, though my 2007 SR8 had two TPS sensors and was open loop. Charley: this seems like a great “ask Phil” question: What was the evolution of the GCUs through the years?

Posted by: @parsonsj An easier clue: if the car has a separate gear position display that's not integrated into the main dash, it's probably open loop. Both my rental cars have Closed Loop and are e...

Hi Charlie (@CharleyH), here is the colour codes list I have from Radical: C = CarbonG = Gloss C1 - Carbon Wet LayC4 - Carbon Pre Preg G0 - No Colour (I guess this is fibreglass raw - no gel coat laye...

Attachment : Photo 25.09.19, 18 38 07.jpg This is what a Closed Loop GCU looks like... 🙂 Main difference is the additional USB plug. 😉

Thanks I just ordered a connector kit. I'll probably go the solder route. I have lots of solder equipment for my ferrarifobs.com thing.

I have some moulds (sorry no clams) here in Tamworth, Australia that may help someone down here, I'm more than happy to send them if anybody gets stuck. I have the front splitter mould and its templat...

Posted by: @charleyhradicalsportscarregistry-com Russ(@russmcb), Here is a picture of the clutch slave cylinder on an SR3. Hope this helps, Charley by: @graemed paragraph 11 Fantastic. Than...

I've been doing a bit of research on factory torque setting mainly because I need to take them with me to race meetings (there are occasions when I'm not the wrench spinner) and also because lots of t...

I've been meaning to post for ages and well it's not like we all don't have time at the moment Charley.