CharleyH .

I made this video about a way to set and verify the pinion depth of SR5 and SR8 gearboxes (the Quaife Q58 and Q72 boxes repackaged by PowerTec). Maybe it will help someone... 🙂 I'm working on the sequ...

Yes it's very strange, especially that all 3 master cylinders were frozen and looked identical with the rust you see in the picture. Knowing I wasn't putting them back in the car I put one in a vice a...

I picked up a car this weekend that hadn't been on the track in a year. It was stored in a nice garage with no obvious moisture issues. However, neither the brake or clutch pedal would move. I discon...

@charleyhradicalsportscarregistry-com Sold! I'll give them a call. Thanks so much for finding one for me.

@charleyhradicalsportscarregistry-com Thanks Charley. I'll give Chris at SM a call tomorrow and order a set.

@charleyhradicalsportscarregistry-com correct, I ordered two sets last time and that is what stuck him my mind!!

@m22ble if you have paddle shifters, look and see if you have a box anywhere that looks like this: Attachment : 20191006_080029.jpg

Update: The issue was the pump wasn’t primed. I followed the instructions in the previous post and intentionally overfilled the GDU by about a quart and after spinning the wheel by hand about 3 revolu...

Hi Sam, That is correct that you remove the red circled inspection plug on the left side and fill from the top blue circled plug until fluid drips out the inspection plug. Make sure the car is level. ...

I just have to say I have gotten great parts service from this Radical dealer, the parts I have gotten from them have been priced lower than the other dealers. ask for Nick & Adrian, good guys. ...

@johnsopa my swirl pot has two hose barbs, one goes into the tank, the other is an overflow I run my coolant level about 2” down from the bottom of the filler neck. That leaves enough room for expa...

Here is where I just mounted mine, the factory connector is in this location. Attachment : FE1EF7ED-215A-462F-B93A-541196935341.jpeg

Charley, thanks, that helps. The SR3 setup is much easier to access. The SR4 radiator is further forward, basically in front/left of the seat. I think I'm going to mount it near the battery somewh...

@charleyhradicalsportscarregistry-com thanks Charley. i sussed it last night. I disconnected at the fuel rail (the left hand side look at it from the rear, filter side), then used my power probe to pu...

Found a video on YouTube on how to bend it... looks like a torch will do it. Spring Mountain is going to quote me on how to do it, if reasonable I may just buy from them. Not sure I trust myself not t...