CharleyH .

I can do that!

You might want to check with Spring Mountain on their broadcast details since digital radios have to be all programmed up and such. If they broadcast analog then a basic BaoFeng UV-82HP is a cheap ana...

Charley, Great post and explanation on the cables! The amount of information that is stored between the dash and ECU is awesome and is an excellent tool to become a better driver! I bought a set from ...

John, I was in exactly your same situation a few weeks a go and went through the process. As others have said you have an FIA sticker that will answer all the cage questions. Unfortunately I didn't ...

@crit I did not, they are smooth, not perfect, but good enough for another 50 hours. The clearance is .0018”, slightly larger than oem, but well under the .0031 limit.

It’s going back together, new main & rod bearings New transmission clips seals note the difference between the RPE shift drum stop & the Suzuki OEM part. Attachment : 5095DE8D-7269-44E7-AA...

I buy used tires from John Berget I will have to check my sizes, I think they are 7x20.5 front and 9x20 rear. I tried 10x22's on the rear but they hit my side pods and tail during a session. I run t...

Bringing this back, adding a data point. I did buy a dry sump kit from Dan, thanks Dan. It will be installed at the end of my refresh. My sensor is going to be installed in the oil tank, like all the ...

@trakmnky Happy Holidays! It's been almost a month, thought I would check in, did they figure out the oil pressure issue?

Thanks Charley. The biggest difference was the driver's position. Driving on the right side of the car is very different. 🙂 My impressions (without any data analysis, yet) are that the new car has bet...

Just made this this morning. Will be useful when the new clutch goes in. I used the old steel plates, some had hotspots on them anyway. Attachment : 19BEE6D3-B33E-4FD5-9BDA-70FEA08BC49E.jpeg ...

Do you have a picture of the other side of the head? From what I can see I think you are still running with the titanium valves. Personally I would recommend upgrading to Gen 1 steel valves and sprin...

Cylinder head & valves showing bucket and shim. Attachment : 31C47351-5250-4B53-9DBB-BF968902CDB8.jpeg Attachment : F1562F88-AAE4-4731-AA99-248B7890919F.jpeg

Clutch photos: The basket with the back plate welded by RPE Attachment : F298E00B-B247-4897-9136-CE68C42F76F0.jpeg Attachment : FE790F84-82C0-47A0-A3C9-84D49F08AAE8.jpeg center hub with...

Here is mine from my RPE1340, Wet sump, manual shift. these are before I started the refresh look at my refresh thread to see what the condition of the engine was in when these samples were taken. ...