CharleyH .

@ajiman as Charlie said it is important to know that Radical log hours based on total running time. This means that an engine that has done 10-15 hours on track could be well over. I know its a stupid...

Well progress was definitely stalled for the month of July and that ran into August as well. I have been doing a lot of cleaning, selling old car parts, ect... to make room to work on the car. However...

Got mine yesterday. Shipped fast and show relatively little use, just as advertised!

Posted by: @joep Got mine yesterday. Shipped fast and show relatively little use, just as advertised! Thank you for that unsolicited positive feedback/comment!

@ajiman That is perfect, that is the later one used. The early versions of this did sometimes have problems with the temp reading and turning in the housing. You want to be replacing it with Bosch 0 2...

Posted by: @ajiman I have an additional question. Is the temperature sensor on the left side of the block an OEM hayabusa sensor? Or is it something different? Thinking about replacing as the reading...

Wow, I thought the SR3 was mentally and physically demanding. My only comparison is my other race car, 2300 lb factory five challenge cobra with 600hp. The SR3 takes everything I got running the car...

@ajiman That additional spacer is just for housing the additional temperature sensor. This was used on earlier cars for the dash, so if you are not using the whole block can be removed. The thermostat...

Thank you so much Charile! wasn’t that bad very lucky! Yeah I will be calling Monday. thank u

With no intention to track my SR3 and a refresh needed of existing K7 engine, my thinking is to swap the engine out for a stock used K7 engine and enjoy the car on the road, with existing engine crate...

Good turnout considering they closed the Canadian border on us. A great time was had by all! Had a couple minor technical issues but everyone pulled together to make sure we all were able to hit the...

Have shipped half the sets out already.

Neil, MK Technologies which has an add and info on this site makes all the equipment you need for lifting the car if you wanted to go that route. A recent post by a forum member talks about it. N...

Neil, I have an SR3 but I think they're pretty much the same. That said here's where the stands should go in the rear. You want them as far rear as possible without pinching the area the diffuser nee...

Thought I would share a solution I found to hang the steering wheel on the SR10/SR3X. I hang it from the 1 inch bar behind the plastic dash. It was hard to find one that would fit that small of a ba...