CharleyH .

@grouparacing. Very cool. I’ve been following Jackie’s racing on YouTube for a long time. He’s an incredibly dedicated racer. Love his enthusiasm for the sport.

Well at least you know it is 100% the problem! Hope you get sorted and let me know if I can help at all.

Now MSR Houston Counter Clockwise with the one and only Jackie Ding behind the wheel.

We will be at most NASA North East events this year with Radicals racing them.

I TT with NASA mid atlantic at summit point and VIR mostly. I'll probably see you at the track. I live in MD and have a 2014 SR3.

Hi John we run the OEM bleed from under the cylinder head into the lower water pipe so there is always a small amount of water circulating and bringing everything slowly up to temp. We do see a fluctu...

No worries John, just let me know if anymore info is needed! Just wanted to make sure I was not causing any confusion with temps.

@charleyhradicalsportscarregistry-com it's 00828 and it's a 1500. NY sounds like a place closest to me, maybe I'll give them a call. Thank you!

As Manny said but if you are checking the stator output on the 3 pin plug then you need to be doing this in AC on your multimeter. You should then check all three options over two pins if that makes s...

Posted by: @rlm-dan Hi Brad, It is indeed a OEM Suzuki crank sensor and one from any year will fit. Unfortunately Suzuki only sell the sensor complete with the alternator windings so you need to buy ...

Just thought you might all enjoy the sound of a 1440cc Hayabusa engine singing on the engine dyno. Attachment : 7dd2d86c-6424-4394-acd7-1538f327b386.MP4

Posted by: @parsonsj @rjbender Love it! I'm stealing your idea! Similar to that, I use the AiM LEDs on the dash (I have an MXS 1.2). Solid Red is too low, slow flashing is too high, and fast flashing...

Hi Brad, It is indeed a OEM Suzuki crank sensor and one from any year will fit. Unfortunately Suzuki only sell the sensor complete with the alternator windings so you need to buy this complete assembl...

@rjbender, in my case I put the heat pad on the swirl pot and added a power pigtail to the water pump so it can be energized by my CTEK charger in supply mode (just like you do for fuel pump out) in o...

Yes -- me too: on the roll bar tube. I've seen them done on the backs of mirrors though that's on gel-coat rather than the powder coat of the tube.