CharleyH .

There should only be traces on the magnet. This is what the magnet on mine looked like when I changed fluids right before I had the engine overhauled after 40 hours. I suspect that the previous owne...

I have never hear of or done this. I just fill it until it starts to flow out of the fluid level hole. One time I tried over filling it a little thinking it would help to have some extra oil... This...

Posted by: GraemeD That looks like it’s from the movie “Ghost Busters”! I would remove them, disassemble, inspect and replace all the rubber parts. As you know, brakes are one area that you want to h...

Today I scooped the gel out of the master cylinder. The blob was quite large, but the good news is that gel doesn’t appear to be it the brake lines. Now I am waiting on the parts to rebuild the calip...

Well, today I was working on my 2000 Prosport project and it took an interesting turn. This car had been sitting in a car collection for 7 years so I decided it would be a good idea to replace the fl...

Wouldn't this be the same connector that is used on the SR3's with MBE ECUs?

Yes, I was going to suggest Spring Mountain also. It is amazing how many parts they have in stock. I was talking to them yesterday and they were telling me that they still have quite a bit of stock ...

This is likely a part / tool that is best purchased from your local Radical dealer. Charley

Nikolay, Another thing that could be affecting the blippers ability to function properly is your throttle cable. It could be out of adjustment and not letting the blipper blip the throttle enough to ...

Posted by: Brandon Fosbinder Nikolay - in my case, the shift never initiated because the wiring harness was clearly torn. In your case, and Charley will probably add in, I think yours sounds like a p...

Hi Nikolay! This sounds like it could be a blipper issue (because you are hearing the pneumatics, but it wont downshift under load) Did you check the blipper wires as we discussed? Also you can have...

Here are a couple of pictures of what the charging / jumper leads look like with the Anderson connector. Attachment : Single battery.JPG Attachment : 938 2.jpg

Oh, lithium to AGM...got it. Putting it in the cockpit would work also. When people have the batteries in the side pods they often use a short jumper with an Anderson coupler to jump the battery i...

Brandon, I believe that is the Reverse switch. It should have a Green/Black wire and a Brown/Yellow wire. To the best of my knowledge this just operates "Back up lights". Here are a few graphics th...

If you are going to relocate your battery I would look at putting it behind the left side pod like on the 24v SR3’s. You may have to move it forward more to clear the air inlet? Also, you mentioned ...