David Flynt

Well at least somethings have been eliminated! If you did not fit new spark plugs on the engine swap I would 100% be doing that before anything else - although it is worth keeping in mind as you say t...

@davidf, I would run the engine long enough to determine if each of the cylinders is heating up at roughly the same rate. You can do this with a non contact thermometer on each exhaust primary or th...

This sounds like one of those fun issues! If the problem has been with a previous engine and now one this one then we should be able to rule out the engine. I would also suggest that it isn't a proble...

Here is a short video on how to change the Gear Ratio sets in the SR3 Gear Drive Unit (GDU). Attachment : Cover a.jpg

I just posted a video of how the SR3 Gear Drive Unit (GDU) Operates that I hope people will find interesting. 🙂 Take a look: Attachment : Overview Cover.JPG Attachment : IMG_0454.JPG

Hello everyone, I placed an order for a SR10 back in November and it was finally delivered this week to Wisko. I've been a member of VIR for almost 15 years and will be using it primarily for HPDE ev...

Tear offs knowledge seems to be hard to come by, as helmets vary and everyone has their own experience. Dirt track drivers seem to run stacks of 10, and pull them off as a normal part of every event, ...

Engine can come up or go down dependent upon what you use to remove it. Strip all the cable ties off, water and oil dumped. Three oil lines underneath (scavenge, feed and pressure sensor) and the cran...

G'day All, Competed in the first of four Rounds of the Tasmanian Circuit Racing Championship last weekend, held at my local track, Baskerville Raceway. It's a 2km circuit and has a lot of really good...

I'll add a few differences for the 1st gen SR3's. 1. The radiator is not bolted in top/bottom. It comes out by sliding it out once the side pod is removed. You need to disconnect the top and bottom ho...

Dan, I normally use the backplate as a guide as it's 5mm. If any part of the pad is less then the thickness of the back plate I replace them. Like DavidF I normally pull the entire caliper off and sw...

I was just going over my car after weekend event, when is recommended brake pad replacement? I had previously purchased a spare PFC pad set 7745.01.16.44. These pads are 16mm total thickness = 5mm b...

One dealer told me anything under 6 mm is worth changing.

@davidf - perfect write up and once again shows that we are on very similar 'learning curves'. I purchased the exact same syncrometer, and followed almost the exact same process. If I followed your s...

I aware of the Radical Cup series and also private club racing(apex, autobahn, SM, etc). Where else is the Radical eligible to race? Perhaps most folks are just using them for track days. The Radical...