This user account status is Approved

Forum Replies Created

RE: Corner Weight Imbalance on SR3 XX

Also be sure to loosen the adjusters for rebound, high and low speed bump all the way.

In forum Suspension setup and Handling discussion

2 years ago
RE: Hankooks -- does the direction matter?

Hi John. According to my driving coach and Hankook, after the first heat cycle, it is fine to run the slicks in reverse rotation. I swap my dry tires left to right after 3 or 4 cycles to keep the we...

In forum Suspension setup and Handling discussion

2 years ago
RE: Corner Weight Imbalance on SR3 XX

I checked my scale start point when I last set my ride height. This is the starting point after doing all of the setup steps but before final corner balancing. LF/RF/LR/RR(pounds): 204.6/407.4/514.8...

In forum Suspension setup and Handling discussion

2 years ago
RE: Corner Weight Imbalance on SR3 XX

Hi Ron. I don't have an answer to solve this but I would probably first check your scale accuracy and ensure they are dead level. After I carefully set my ride height, I am typically way off on the ...

In forum Suspension setup and Handling discussion

2 years ago
RE: Installing SmartyCam3 corsa camera on 2014 SR3

@tmpoquette Hi Trevor. I am not an expert on this data and camera stuff -- I learn just enough to get everything working, and then I kind of forget about it. A couple of things to pass on: - each t...

In forum Data Acquisition and Analysis Discussion

2 years ago
RE: Stuck wheel Nuts

There is an old thread about anti-seize grease causing the wheel nuts to weld onto the interface of aluminum wheels, requiring the nuts to be removed by cutting. I have not had this problem but I reg...

In forum General Discussion

2 years ago
RE: Recommended Engine and GDU oil

I always have. Many also run Neo Sythetics 75w90 which might be better? IDK. I think more important is to ensure the exact right amount is in your GDU. Too much and it will spray out of the breath...

In forum Getting Started

2 years ago
RE: Stuck wheel Nuts

260 foot-pounds

In forum General Discussion

2 years ago
RE: F1 Style Halo / Center protection

@rjbender Excellent point and idea Rod. I will see if I can fit a temp strip where you indicated.

In forum Safety Gear Discussion

2 years ago
RE: F1 Style Halo / Center protection

@rjbender Hi Rod, Yes, these are what I have on my SR3 uprights -- Temp range B 71 to 110 C. I have reached 104 C on my uprights and beginning to reach 110C, including a new one, so I guess that i...

In forum Safety Gear Discussion

2 years ago
RE: Radical Racing Simulator Options?

@parsonsj It begins with a driving sim cockpit which holds the screen, pedal set, steering wheel, keyboard tray and mouse, and is your seat. There are many choices out there for these components; ...

In forum General Discussion

2 years ago
RE: Installing SmartyCam3 corsa camera on 2014 SR3

I just switched from the SmartyCam 2.2 HD 2.2 to the 3.0. on the 2.2 my GPS09 plugged into the camera, and the camera plugged into a CAN hub. On the 3.0 there are only two cables which plug into the...

In forum Data Acquisition and Analysis Discussion

2 years ago
RE: Radical Racing Simulator Options?

I use iRacing mostly, and Assetto Corsa for tracks that are not in iRacing. They are very helpful in learning the tracks and getting faster, but there will be small differences in actual braking poin...

In forum General Discussion

2 years ago
RE: Dry break to normal fuel cap?

Below is a picture of the fuel cell foam being prepared for the fuel cell. This was from my 2021 SR3 XX which required a baffle upgrade to keep the fuel from rising upward, which is not really worth ...

In forum General Discussion

2 years ago
RE: Dry break to normal fuel cap?

My car is the same. There is fuel cell foam in the fuel cell, which I suspect causes flow restriction. Without the foam, the fuel will move to the outside during a corner, causing the fuel pump to r...

In forum General Discussion

2 years ago
Page 3 / 27