Gareth Rees

Thanks for the info. After a lot of internet searching and actually speaking to real people! I have found that over here in the U.K. a complete assembly is a FG1079-12B1. Got to say, it has not bee...

Hmmm……just seen that I forgot to put some info on it. Is the Delphi one I need here?

Attachment : Fuel.jpg Attachment : Fuel 3.jpg I just posted this on a fuel pump thread.....but realised the thread is 2 years old! Prob best to post a fresh one.... My fuel pump from my SR3...

Attachment : Fuel.jpg Attachment : Fuel 3.jpg My fuel pump from my SR3SL.....it has suddenly stopped working. As can be seen there are no part numbers on it....Is this the Delphi one? Thank...

Bet that won’t cost £377.......

Cant really find the old stripy pic of the prototype SL. But I did find.... Attachment : Car.jpg and my car...... Attachment : 1.jpg Attachment : 2.jpg Attachment : 3.jpg ...

Thanks Charley. I have contacted Radical, I have seen on their shop that they sell a motor assembly. They have not got back to me with a price yet. But, I contacted Parvalux and they quoted me aroun...

I presume no.1 was used for crash testing etc.? If you google the car when it was first made and unleashed on the public....you will find that those naughty chaps at Radical had actually swapped the n...

Hi, I have a SR3 SL and the compressor motor has become quite noisy. I presume it is the same one fitted to the SR3 + 8. I thought I would have a quick nose and the casing / shaft is quite loose....

Interesting this.... My SL was the first one they made (Daisy) with following plate... Attachment : Chassis.jpg As you can see, it simply has SR3SL....loads of zeros....then 2 They must have ...

@rlm-dan Yes. Although the o rings (one inside, one outside) were still in one piece. they had presumably lost their ability to seal. I dug about in my o ring box, till I found one of similar shape,...

Update.....job done! Good news....the job cost nothing to do. It needed new o rings on the clutch actuator....I dug out one from some bits and pieces I already has Bad news...the job took me most of S...

@rlm-dan Ha!....you are probably not far wrong with the off road bit! I wanted one for a while and apart from trying to buy a new one (radical were not very responsive at the time) I found one for sal...

@rlm-dan Hi Dan Yes Neil has been working on it recently. I bought the car from Andy Cummings (6th Gear Experience) and when the MOT ran out, I found it a bit problematic for anyone to actually look a...

@rlm-dan Thanks for this. I will start on this....sometime! I was looking at things and I will start to take things apart and see how it goes the clutch line goes in / out to the bleed valve...I will ...