Dan Millsaps

I would love to have this halo on my 2021 SR3XX. Exposure (compared to GT car) was my biggest hurdle to overcome prior to buying my car last year. Plus, the changed steering column has to be an impr...

They are identical sized washers on top return oil line and side level plug. @davidf Is your car a SR3 XX? Once you have ordered and received, please confirm their fitting properly. I had orde...

Thanks for responses. I am headed to track using existing wear pads this weekend. I will report back later when I dig into this fix more.

Wow, mine is 2021 SR3 XX also. But, no rivets, all flat head allen screws that just spin without backing out or releasing - for both center and front corner.

Ok, more dumb questions. How does one replace these wear pads. Do the tapered hex screws underneath have a hex nut on back side up in splitter itself? If so, how does anyone get to that location si...

FYI to all: GroupA was super helpful and best pricing/availability from several different dealers, easy transaction.

@grouparacing Can you send me an email quote to 617dmm@gmail.com with pricing and freight for shipment today? Please quote 2 ea of right side, 2 ea of left side, and 1 center pad for 5 total? These...

Wow, Radical dealers want a lot of $$ for the side and center wear pads on underside forward edge of splitter. Has anyone found alternative materials or sources? Mine have worn down almost flush wit...

Wow, never had that issue with my PC wheels, just the opposite. Could hardly peel weights or adhesive off.

Interesting, I have not heard that about forged wheels. I had a set of wheels that were powder coated and loved it. In light of your comments, I would reach out to Finspeed, BBS, TireRack, or other ...

I have very small seeping oil leak from this where the AN fitting enters the housing. What is this - oil pump? Seems as though the top crush washer is source location for seepage, but seemed very ti...

Belmetric did not carry the correct size, so I talked to them and they added them, stock is due in today.

Do yall have a spec and/or source for buying replacement rubber insert washers for the GDU top inlet and side level plug? They appears to be same size. I measured 28mm OD x 22mm ID x ~17mm rubber ID...

What about 260 GTX, is that good or bad? The pump shows 100 octane but the label says 98. It is the only fuel at MSR Houston.

I forgot. One of those dealers actually replaces the factory drive pegs/nut with special Knuts & loctite, then dont worry any more as they apparently stay tight better.