Owner of Radical SR3 RSX and SR3 XX
This user account status is Approved

Liked Forum Posts

RE: LIFING: suspension bushings?

I don't have experience replacing bushings yet, however I have a plan to strip all of my suspension components and bushings at the end of the season (now), when I will visually inspect each bushing in...

In forum How To / DIY Discussions

3 years ago
RE: RC) file uscalibration (.Led in this car and any available data logs?

Here 2 pictures of up and down shift from the movie Attachment : EFFB0A6A-0217-4262-818A-166B6DB5E190.jpeg Attachment : 164B8851-8F19-4BB5-A696-2D2879E3FF8C.jpeg

In forum Prosport / PR6 / Clubsport Specific Discussions

3 years ago
RE: RC) file uscalibration (.Led in this car and any available data logs?

@kuddby-racing, the pictures you posted are very helpful. As Dan mentioned your paddle system is a Geartronics system. Unfortunately I don't have a wiring diagram for that system but if you reach ou...

In forum Prosport / PR6 / Clubsport Specific Discussions

3 years ago
RE: Something broke today

Washed and ready for full test day next Monday! Attachment : PXL_20221002_193705091.jpg

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

I would say I have been rather successful in this rebuild. Started up just fine runs fine and cycles through the gears just fine. On Sunday I plan to blast up the street to see how it is under load ...

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

Thank you Sir!

In forum SR3 Specific Discussions

3 years ago
RE: Track videos

Back at oulton park for a proper go, after the first time was cut short with my rectifier blowing. Track was fully wet all morning then finally the intermittent showers stopped, the clouds broke, and...

In forum Track / Race Videos

3 years ago
RE: General prep after a wet day?

I don't run cars so not the best person to answer this but personally I would be going over the car with ACF50. Its a water replant that protects from corrosion etc. The only thing to avoid with this...

In forum General Discussion

3 years ago
RE: GDU mechanics and 1st gear selection

As mentioned this is normal, due to the design of the gearbox. The gears all have 'dogs' on which engage with each other as you shift gear. This all works well as the gears and shafts are all spinning...

In forum General Discussion

3 years ago
RE: Need advise: something weird happening after engine rebuild

Try this, see attached. Attachment : TPS issues.docx

In forum General Discussion

3 years ago
RE: Need advise: something weird happening after engine rebuild

Posted by: @raider89 (@davidf) Have you experienced this with your new rebuild? That refreshed engine is still in its crate, so I cannot answer or compare until I swap that engine and test. Pos...

In forum General Discussion

3 years ago
RE: Ramp truck for radical

Very Nice!

In forum Towing / Trailers / Truck Discussion

3 years ago
RE: Help again: clutch problem

@rjbender Thanks! we’ll soon find out. Since I’m nearing the life of the engine and planned a winter rebuild I’m just loosing out on a few fall sessions - unless more damage was done internally. We’l...

In forum General Discussion

3 years ago
RE: Oil Analysis "Analysis"

Interesting that Motul are discontinuing the 15W-50, not something I was aware of. @rjbender interesting info reference our conversation, might explain why they have the change in recommendation. I am...

In forum Oil Analysis Discussion

3 years ago
RE: Oil Analysis "Analysis"

This is interesting, I didn't realize their main recommendation was off road spec oil, the few local guys in town here run the factory line recommended by our tracks shop. It drives me nuts that motul...

In forum Oil Analysis Discussion

3 years ago
Page 32 / 63