Rod Bender

@davidf - great info - thankyou. There's just one more dimension I would need - could you help again? Attachment : image.png

Thanks Charley! - Does anyone know whether the 'new' SR3 (with the raised Steering Column) also has the billet uprights as standard fitment or are these options? Same question for the updated roll-ov...

@davidf - regarding your comment "On a different but related topic, I use a 3/8 inch size 19mm non-impact socket (made by Gearwrench) to remove the reverse sensor and and index plunger/detent when dis...

@davidf - G'day David, Is the clearance you refer to 'under the centre wear strip' or measured in the outer edges like you have in the picture? Also, are you measuring to the splitter itself (ie to ...

@raider89 ... it's definitely NOT physically impossible to get the mating surfaces on the rims/wheel nuts to be identical in how they come together. In fact its fairly straight forward for any decent...

@davidf - Thanks David, Sheesh!! - glad I asked that question before I got into the job! - I appreciate your reply as it will save me time and frustration when I finally get into it!! So based on you...

Great Video Charley! - I'm about to do my first ratio change (while the GDU is in the car) and I'm purchasing the 33mm, 42mm and Loctite 648 Compound. Just wondering if I need anything special in term...

@rojid ... I know this sounds stupid, but are you sure that one of the batteries isn't connected in reverse? I'm not exactly sure about where/how you're measuring the voltages, but it seems strange t...

@parsonsj - G'day John, No - the fuel cell bladder in my car is the original from October 2015 build (although the car did sit in my garage for nearly 3 years without use....) I don't have any issues...

@davidf - I installed a brand new engine from Radical late last year as well... and had EXACTLY this issue. After many, many attempts to increase idle speed and modulate the throttle to try and get t...

@darrahc - G'day Clark, That looks ok to me. You might want to get the front of the car as far forward as possible to make sure the centre of gravity for the car is close to the trailer's axle cente...

@rojid .. I doubt the starter motor will be making the noise, more likely a relay in the starter circuit. I've never had that problem, but would start by pulling the starter motor out and checking if ...

@kirk - G'day Kirk, It might depend on which car you have (and which model Hyabusa)? I have a 2015 RSX and it was literally 'plug and play' (see my previous posts and replies from other members in thi...

G'day Josh, Yes - correct in both cases. Interestingly my dipstick has different 'notch' positions to yours which I think makes it more obvious. Mine has the notches on the top two blue marks in your ...

@tommymills - G'day Tommy... Eagles Canyon looks like a fantastic track. Smooth driving! I appreciate your reply and the photos to make it clear. My camera controller is located in exactly the same ...