Stephen Davidson

Just a quick one - Are the upper and lower lights, the main and dip or is it the other way around? My Radical came without a front loom, so I'm unsure which way to wire them. Attachment : 543563.j...

Excellent.

I found the easiest way to load it onto a trailer was to start with it on a trailer, and put the two tail to tail. We just pushed her from one to the other on the level! Long low ramps seem to be the ...

That looks rapid!

Interesting. I've also read about folks having a sensor of some sort which only reads a low level (on/off), rather than the levels as it drops. Apparently this may not be reliable either!

I noticed that there are two extra pins on the fuel pump connector. Attachment : 20190907_155303.jpg Is this attached to a fuel level sender on the underside? How is fuel level displayed?

Hi John, thanks for your reply.Yes, that's my understanding too. I'll connect the IG terminal to the '+' 12V wire for now, until new information shows what the other wire is for.

Would anyone know the correct wiring for the alternator? I recently discovered someone had put spade clips directly onto the alternator and sealed them up (see pics). Attachment : 20190904_215251....

As suspected, one of the pins required a little squeeze - I had noticed when the wires on the back of the connector were moved, the values changed on the software.Also the pressure sensor required rep...

I think one of the pins on the connector for the pressure sensor needs replaced, or given a little squeeze, I'll hopefully get that sorted soon. Yes, I'm in the UK. Best send an email to Geartronics a...

It turns out that the the Geartronics unit had some water ingress and has now been repaired. I must say that there was a quick turnaround from Neil @ Geartronics, who also upgraded the firmware at the...

There's some info on the Geartronics site about this:

He's right on the money - the car is an early SR8 (Gen 2), so has the Geartronics system. Were going to swap the sensors around and plug into the Geartronics ECU to see what's happening. I'll pick thi...

There are three wires going to the sensor/switch. Live (12v) , earth and a yellow wire. I measured the voltage on the yellow wire as the pressure increased, and there was no difference throughout (0.1...

Hi John, Thanks for your reply. A known working sensor may help to solve this. What is confusing me is I've checked continuity between the switching pin of the relay (negative switched) and any of the...