Trevor Poquette

I read that thread. They were referring to a bias ply hoosier tire for an older model radical. The Radical SR3/SR8 hoosier specific tire is a radial. So, I would think the suspension settings are t...

What are the alignment issues with the front wheel tie downs? I wasn't aware that securing the front wheels can be an alignment problem.

I have two sets of dunlop slicks. They seem to love heat. When it was 90+ ambient temps, it took about two laps to get hot. As I pushed the car harder and harder, they gripped better. It was to th...

For an SR3, is it the standard brake bleeding that is typical of any race car? Start with furthest caliper, push pedal, have tube in fluid, open nipple, close, release pedal, repeat a few times, move...

great, I'll try the Motul oil

I changed my oil a few months ago with the recommended Silkolene Pro-4 Xp 15w-50. It is time again for the oil change and I can't find a company that sells this oil. Motosport and Dennis Kirk have d...

As a mechanical engineer, it doesn't look good. Those small cast aluminum ears are not very robust to hold all that cantilevered weight. I would support it on the other side too. I use the same type...

I bought the cable recently, it was $155. Your price sounds reasonable.

The suspension uprights from all different year cars, one as old as 2008 (my car is a 2015). One with a crack that was circled to "keep an eye on it". Front spherical bearings worn, causing the car t...

Problem solved. In the shifter wiring hardness, one of the small plugs had a damaged pin connector. Leave it up to the experts at Wisko racing. The air compressor was rigged to be powered directly ...

Hi Dan, I didn't have any luck after the pressure sensor switch. I was thinking it was the ECU. That is good news to me that other sensors are on the same circuit, hopefully it is one of the other s...

The relay works. It turns the pump on. I took the cap off and can see it close when ignition is turned on. The problem is the pump won't shut off. I replaced the pressure transducer today. Same re...

When I get back in town, I'll take some pictures of the diagnostic screens and see if anyone can make sense of them.

Thanks for the information. I figured the pump didn't have to run very long on the initial fill. I will try swapping the relays, that is a quick check.

So, my first track event was a bust. The shifter does not work. It strangely worked when I was messing around in my neighborhood back in Nov. First problem (I didn't know was a problem), the compres...