Hi Mike (@mikesmith), The Prosport I had (RMS0108) had the shift pushrod attached above the pivot point of the shifter so pulling the lever back woul...

@gobble, Can you post a picture of the top of the plate to better show the pneumatic solenoid and another picture of the actuator? The reason I am as...

@mikesmith, pixi dust doesn’t sound good. I would send a sample to black stone and have them analyze it. Is it ferrous?

@tommymills, As Graeme said the 3.5 plug on the side of the dash is the proper port for downloading the Aim Data. Most Radicals also have another lar...

Welcome Brian (@sr300259)! Congratulations on getting an SR3. Based on your question and the pictures in the Registry of your car I assume that it i...

@tommymills, Unfortunately I don't have any pin out information on the cable or know who makes the connector.

@tommymills, I usually get my parts from Spring Mountain. Unfortunately, these cables ar pretty expensive. I believe they are ~$180 but it is a good...

The only temperature challenges I ever had was getting enough heat in the engine. I never experienced oil temperatures that were too high. Do you ha...

The ECU is likely on the front firewall of the engine compartment. Is your engine carbureted? Also, do you know what the engine serial number is? ...

Hi Josh (@meatman), To find the wheel speed sensor look closely at each of the front wheels and you will see a wire that comes over to the wheel hub....

This car appears to have been originally equipped with the dry-break refueling system. That is the vent connection for the dry-break. The dry-break ...