BTW, the 30 hour load time that I repeated is not the guidance that Radical recommends, so I do not support it myself. 40-45 hours run time is my rul...

@rojid OK, so the standard open-end blind rivet with a dome head are what you should use. I don't know for sure the exact size but my guess is 4mm...

What panel and where? Peel rivets should be used for soft materials like fiberglass or carbon fiber where you are unable to use a backing washer; for...

Rod, I don't have an answer but I noticed recently that one of the sensor cables which is close to the exhaust is shrouded with a loose heat shield tu...

Dan I plan to send my 45 hours run time/27 hours load time engine to Spring Mountain today. I consulted two Radical techs who have maintained ma...

@darrahc Nothing to update on progress and problem still persists. I have had to take a break from diagnosis because of my busy race schedule, how...

This is what it looks like. I use a 1/2 inch drive by 5 inch length wobble extension and a 1/2 to 3/4 adapter. The adapter touches the frame and has ...

30mm. Overall height is 46mm.

The nut thickness is 8mm, 6.6mm not including the flange thickness. I have a few extra of these if someone needs one. $75 plus shipping.

I use distilled water and 1/2 bottle of water wetter. Anti-freeze if there is a chance of freezing temperatures. Don't start the car, but turn on po...

Nice. I use a Snap-on bent 8mm/10mm wrench for brakes and clutch bleeders. It is tight but it gets the job done.

@rjbender Nice drawing! I have a wood block that is 46mm thick which I use this to measure height from ground in the places you noted. I measure ...

This picture shows the bottom of my diffuser. Clearly this is not an ideal design to expose fasteners and fiberglass to frequent contact with the gro...

I have the same experience that the grease looks fine after 10 hours. I was going to stretch it to 40 hours, however techs have suggested more freque...

@rjbender Hi Rod. Unfortunately I cannot give you exact measurements at the moment. In the photo of the two 42mm sockets above, mine is on the le...