Dan Phillips
Dan Phillips
@rlm-dan
Reputable Member
Joined: November 13, 2018 2:25 pm
Last seen: August 29, 2026 12:02 pm
Topics: 7 / Replies: 297
Reply
RE: Waking up SR3 / #254 / 2006 Supersport from long storage

Glad to see that you have made some progress with this! As Rod as mentioned it is a Jenvey sensor, the TP1. The TP11 they offer has the same lineari...

3 years ago
Reply
RE: Waking up SR3 / #254 / 2006 Supersport from long storage

Thanks Don and apologies for not understanding correctly. The first thing I would be looking at is your throttle body set up, one of the Radical man...

3 years ago
Reply
RE: Waking up SR3 / #254 / 2006 Supersport from long storage

If it starts and sounds ok when warm it is worth keeping in mind this is a slightly older car on an older version of engine management. In my mind t...

3 years ago
Reply
RE: Geartronics and LifeECU questions.

Adding my thoughts to this. The ECU battery keeps track of engine hours so when it goes flat this will be forgotten. The date shown is the last time...

3 years ago
Reply
RE: New Owner from South Wales

Welcome Nick! Most 1300/1340cc cars start with a 16T front sprocket (suspect you could be 14/15) then rear from 41-46 ish. 16 on the front and somew...

3 years ago
Reply
RE: charging second battery for 24v system

My thoughts on other options are: 1. Don't bother with charging for the battery, it is only being used for starting so if you charge it up every few...

3 years ago
Reply
RE: Spin Safe Clutch and Starter Motor in SR3 XXR

Welcome to the forum! Looks like you have covered the repair and as always Charlie has you sorted with information! The reason that you damage the...

3 years ago
Reply
RE: Performance and Cost Comparison for Radical SR3

Shame to hear of your problems David but as Charley mentioned it is a learning experience and information for everyone. Hopefully the refresh is nea...

3 years ago
Reply
RE: SR8 cutting out

If you look on the underside of your car just behind where the oil tank/bell housing is you will see a small grommet that has a wire coming from it, t...

3 years ago
Reply
RE: SR3 RSX Oil Temp Sensor Failure and GDU Temp Sensor Install...

On your SR8 it is fitted to the bell housing/oil tank. Cannot remember which side but it is an anodised plate on the bottom of the tank, the same one ...

3 years ago
Reply
RE: Performance and Cost Comparison for Radical SR3

The SR3 cannot be beaten on performance vs cost! Interesting comments on hours, especially from a dealer, as I was fairly sure the factory still rec...

3 years ago
Reply
RE: Make at home paddle shifter

The important thing with paddleshift is a closed loop system. This monitors the rotation of the selector barrel and cuts for the required length of ...

3 years ago
Reply
RE: Running wheels off the ground

For an SR3 I would recommend that you do not do this. On older F1 cars, SR8 or 10 etc the main reason is to get some heat into the gearbox oil. Fo...

3 years ago
Reply
RE: Gear Indicator Display

@crimonto They are but he is a one man band, so if he is away on support contact can be limited! Assuming you are over the other side of pond fro...

3 years ago
Page 4 / 21