Last seen: November 23, 2022 7:18 am
@rlm-dan acf50 aerosol or spray bottle preference?
According to SM this beefier clutch piston seal is what is addressed on any “X” rebuilds. Sounds like a common enough issue and going to add cost to t...
@rjbender Thanks! we’ll soon find out. Since I’m nearing the life of the engine and planned a winter rebuild I’m just loosing out on a few fall s...
Update. Got a different ramp truck with aluminum bed and crew cab. First weekend down and loading unloading was a breeze
I’ve been using yellow drywall anchors. Fit great and replaceable easy.
Dan- i just had the same set of conditions. Higher water temp as I had taped some of both intakes for first cold session of fall and pressed in clut...
So I got a set of these also. But was told by a Radical shop that the safety pins scratch the wheels easier then the bolt setup does. Just watch what’...
@parsonsj just ordered their stainless- gonna try that over the ceramic currently in there. I’ll take a few db over having to repack so often.
This is helpful! ”get a PVC pipe (or similar soft material) over the 'through bar' to prevent to bar damaging the nut mating surface inner edge.” ...
Wakka wakka!!!
@tommymills are you Smokey or the Bandit?
Yeah I like the aluma open with the front piece. I was going to put a trailer in the garage just barely fitting but only a 7ft wide trailer would fit ...