General Discussion

Oil Pre Heater, anyone using one?

First post and replies  | Last post by Rod Bender, 5 years ago

Lots of kick back in corners -- due to bias ply slicks?

First post and replies  | Last post by johnsopa, 5 years ago

Be careful -- neutral/low camber adjustment could be dangerous

First post and replies  | Last post by johnsopa, 5 years ago

SR3 / SR8 gen2 Seat angle?

First post and replies  | Last post by Nikki Schumann, 5 years ago

Fuel pump seal

First post and replies  | Last post by Garrett Taylor, 5 years ago

New SR10 coming

First post and replies  | Last post by John Annunziata, 5 years ago

Sr3 rs need help motor running on 2 cyl only

First post and replies  | Last post by Trakmnky, 5 years ago

SR3 low oil pressure light setting

First post and replies  | Last post by Dan Phillips, 5 years ago

Rising High Oil Pressure even at proper operating temp, bad sender?

First post and replies  | Last post by Crit Scholer, 5 years ago

Installing new rotors

First post and replies  | Last post by Gordon Duncan, 5 years ago