Christian Malone

@rlm-dan acf50 aerosol or spray bottle preference?

According to SM this beefier clutch piston seal is what is addressed on any “X” rebuilds. Sounds like a common enough issue and going to add cost to the rebuild now it’s broken. get your “X”’s stamped...

@rjbender Thanks! we’ll soon find out. Since I’m nearing the life of the engine and planned a winter rebuild I’m just loosing out on a few fall sessions - unless more damage was done internally. We’l...

Update. Got a different ramp truck with aluminum bed and crew cab. First weekend down and loading unloading was a breeze Attachment : FAE5EA26-CE97-4BA3-B952-CDE5913F0692.jpeg Attachment ...

I’ve been using yellow drywall anchors. Fit great and replaceable easy.

Attachment : 6817AF28-29DA-48EF-B900-D5D53A7B2427.jpeg Dan- i just had the same set of conditions. Higher water temp as I had taped some of both intakes for first cold session of fall and pressed...

So I got a set of these also. But was told by a Radical shop that the safety pins scratch the wheels easier then the bolt setup does. Just watch what’s hanging down and maybe only install once station...

@parsonsj just ordered their stainless- gonna try that over the ceramic currently in there. I’ll take a few db over having to repack so often.

Not a motorcycle guy so I don’t have a good idea where to source the repack mat for our SR3 1340 quiet muffler. Just trying to make sure I have an option for quiet tracks.

This is helpful! ”get a PVC pipe (or similar soft material) over the 'through bar' to prevent to bar damaging the nut mating surface inner edge.” I might have my tires open air top of the ramp truck...

Does anyone use caution when racking/storing/transport of their wheels due to the center lock style? I assume a thru bar will never damage the center hub surface but wanted to get opinions and any tri...

Wakka wakka!!!

@tommymills are you Smokey or the Bandit?

Yeah I like the aluma open with the front piece. I was going to put a trailer in the garage just barely fitting but only a 7ft wide trailer would fit and that’s just too little clearance for the radic...

Attachment : 289EC779-38CB-4BD6-990B-70404E34239F.jpeg with a 16ft straight wedge bed, 11ft ramps and maybe even 11ft race ramps this should be fine right 😉 gotta be creative with HOA restrictions