CharleyH .

The car can be seen at 7:58 in the video. Not my video, taken by a spectator at the event.

I have the new rotors and they fit fine. George G was right. My calipers had different spacers for a thinner rotor. Luckily, the previous owner passed on, in the spares package, the original spacers. ...

Just thought I'd add my .02 cents in here so hopefully others might benefit. The last race series I was in used a fuel cell. It was common knowledge to not leave reformulated fuel in your cell when ...

Yes, I’m going to run cables to both batteries. I’ll definitely take some photos and upload to the site. I just read your explanation on how to remove the side pods. Fantastic! Thanks for taking the ...

Figured it out and got it installed, looks pretty good in my opinion 🙂 For someone looking to install an aftermarket tach, tap into the radical dash wiring harness and use the power and ground and tac...

I did exactly the same upgrade with SR300376... It came with the STACK dash but had all dedicated sensors (RPM, oil press/temp, water press/temp, etc...). Since I had a data output connector from the ...

Oil and GDU fluid change completed this weekend! An FYI for anyone doing this for the first time, there are some large bolts on the engine and oil lines going to the engine. I started the job not re...

Hi Chris, Yes, you should run with axle pucks (that's my part name, lol). It's made from Delrin (acetal) and is glued in place at the factory with silicon adhesive (Permatex UltraBlack works well). ...

The bearing has failed and needs to be replaced. It has a number on it and you can just order online/from a bearing supplier. You will need to remove the circlip, press it out and remove the insert to...

Assuming it is a dry sump engine drain the oil tank from the main oil feed pipe to the sump. Also remove the sump bung from the oil pan and drain that (even though its dry sump there is still a surpri...

I spoke with Wilwood yesterday. Consider, I only do track days and I am not very fast, think old fat guy. They suggested their BP-20 compound. It is a street/race compound. Things like the Hawk Blues ...

Thanks Charley, I’ll raise the idle. I’m going to install a better tach as I have a gen 1 radical dash and a racepak g2x that has an erratic tach but is pretty consistent with startup idle somewhere b...

I use some 8 foot 2x6 boards to extend my ramp. Here is a pic of my tow package. Attachment : Radical Ready.JPG Total weight of car and trailer 1500# Plus I like the attention I get pulling an ...

@charleyhradicalsportscarregistry-com Apologies for the delay in responding Charlie. Thanks for the info. I’ll, give spring mountain a call this week. john

l’m In Alabama and do track days Barber, Road Atlanta, Atlanta Motorsports Park, VIR, NCM, and Roebling.