CharleyH .

Wow, I thought the SR3 was mentally and physically demanding. My only comparison is my other race car, 2300 lb factory five challenge cobra with 600hp. The SR3 takes everything I got running the car...

@ajiman That additional spacer is just for housing the additional temperature sensor. This was used on earlier cars for the dash, so if you are not using the whole block can be removed. The thermostat...

Thank you so much Charile! wasn’t that bad very lucky! Yeah I will be calling Monday. thank u

With no intention to track my SR3 and a refresh needed of existing K7 engine, my thinking is to swap the engine out for a stock used K7 engine and enjoy the car on the road, with existing engine crate...

Good turnout considering they closed the Canadian border on us. A great time was had by all! Had a couple minor technical issues but everyone pulled together to make sure we all were able to hit the...

Have shipped half the sets out already.

Neil, MK Technologies which has an add and info on this site makes all the equipment you need for lifting the car if you wanted to go that route. A recent post by a forum member talks about it. N...

Neil, I have an SR3 but I think they're pretty much the same. That said here's where the stands should go in the rear. You want them as far rear as possible without pinching the area the diffuser nee...

Thought I would share a solution I found to hang the steering wheel on the SR10/SR3X. I hang it from the 1 inch bar behind the plastic dash. It was hard to find one that would fit that small of a ba...

Thanks Charley, much appreciated.

Thanks, I thought it was for cooling only. SOLVED: I talked to a Radical race team in the UK, explained the issues. They had an interesting take. They had experienced similar issue trying to get f...

Wow, sorry for dropping ball on replys, but there are some good ones. David, Yes, I found hard way that letting it roll back in gear will shred the starter and these suckers are expensive! Lesson lear...

Here is a pic of the back of one of the T shirts Charley sent me. I like the car in the circle with the name surrounding it. Attachment : 20210826_092548.jpg

@parsonsj We will be at Sebring in November, can work packages with you for pickup there

Very nice post. I just removed the pistons from one caliper last night and found it to be difficult without risking scratching when pulling them out. These pistons don't have the outer ring part tha...