Rod Bender

@rojid, This sounds like it is a PDM system issue. Unfortunately I haven't worked with the PDM system yet. Did you check the lights on the sidewall of the cockpit to make sure they are all green? B...

Hi @darrahc, your overall set up looks good but as Rod mentioned you will have to adjust the location a bit. The center of gravity for these cars is just behind the roll bar. When trailering you wil...

Hello everyone, I placed an order for a SR10 back in November and it was finally delivered this week to Wisko. I've been a member of VIR for almost 15 years and will be using it primarily for HPDE ev...

Thanks, Charley! Don't worry, I'm sure I'll be asking a lot of questions! @parsonsj - would love to make it down to Sebring. I was down there years ago for a NARRA event and loved it! @bill-snead - ...

John, you need to drive the SR10 and write up a real world comparison!

Hi Dan (@raider89), I can’t help much here but I can share a few things. Yes, there is a minor loss of clarity when using tear offs, but it is very minor on my Bell helmet. Regarding the folding of...

@rjbender Awesome, thanks for the feedback and the tip. Mine does the same thing if it's too full as I found out the hard way after buying the car (from my local radical dealer) and going straight to ...

Thanks for the info. After a lot of internet searching and actually speaking to real people! I have found that over here in the U.K. a complete assembly is a FG1079-12B1. Got to say, it has not bee...

@gareth747474, Take a look at the Delphi FG1079. This is the pump that has the upper section that attaches to the fuel tank like in your pictures. The Delphi FG0416 just has the lower section of the ...

Great driving Rod. Where is your SmartyCam located in the car? I have mine located on the passenger side wall and get pretty good audio. Not the best place to install SmartyCam Attachment : 2022-...

Think of it has 3 separate systems. You have found the way to connect to the PDM. The SCHD is connected with the USB Mini connector next to the SD card. I'm not sure how your car is wired, but there s...

Hi Rod, Seeing this reminds me I never replied to your e-mail, apologies I will get on this! We go for 60NM. These are generally good and whilst I know it is not technically correct as long as it is t...

Several people have recently asked how to remove the side pod from their SR3 /8 so I decided to share some pictures on how to do it. Removing the side pod really isn’t too hard of a job, it just takes...

I was a little worried that this would be a big job, but it went quite well on my SR3 XX. I left the radiator connected to the side pod, and disconnected two water lines and two electrical connectors...

Dan, I normally use the backplate as a guide as it's 5mm. If any part of the pad is less then the thickness of the back plate I replace them. Like DavidF I normally pull the entire caliper off and sw...