Rod Bender

@walteriv, The lights are made by Raptor Performance. Here is a link to the part you need. Due to the space constraints in the Radical Raptor uses one of their warning lights and then puts the elec...

@walteriv, Let me know if you need a copy of the shift light installation / wiring instructions. Apparently Raptor doesn't keep them on their website anymore. Charley

Thank you for the thoughtful replies. I've decided to go with the SR10. Although I do love the look of the RXC I think the 10 will be a better track day car based on your replies and some conversation...

I am by no means an expert, but I recently purchased a syncrometer and balanced the throttle bodies on two SR3 XX 1500cc. Although the owners manual does not give a step by step procedure, I did find...

@rjbender hey bro, i have about 4cm from the ground and up to the lip. Sideskirt sides are about 6cm or so. Attachment : CAA66A7A-DAAD-4019-9A4D-EB80177C6F83.jpeg Attachment : 7E637D73-08...

Brian james RT4 trailer, i tilt it and use 4x wood about 1m long each.. 2x4" and half that again so i step it up from ground. No need for advanced ramps. But BJ have their own ramps, but thet y are re...

I've seen mine loosen occasionally when torqued to 260 ft-lbs. I think it has more to do with the temperature of the system when the torque is applied. When I torque in the shop and everything is cold...

Wow you guys are making it so advanced.. all you need is a brian james trailer, with tilt, and 1,5m long piece of wood just to make a small ramp. And thats it

Posted by: @rojid Would it be quite easy to repair these holes? Can i just apply some sort of fibreglass filler compound? I just removed the entire half of the fiberglass panel under the roll bar t...

@rojid, David explained the process well. If standard expanded rivets have been used you will likely have to repair a couple of holes but it isn’t difficult. Just use some fiberglass material and so...

You loosen the tension at the foot pedal. There is an adjuster that can be used and a barrel that can be loosened. But you should be able to remove the cable without loosening it. There is a fixed end...

@tmpoquette Are you sure that is not your paddleshift compressor that you are hearing? The water pump on the later LIFE cars should not come until the engine is started. Once the engine is turned off ...

i already have the dry break fuel sampling connector on the car, and i'm struggling to find out what the actual connector is that i need with a bit of clear tubing crimped onto it, so i can drain fuel...

@higgins613, Welcome! And Congratulations on getting your new car! I like this car so much that I was considering getting it for myself. 🙂 You got an amazing car at a fantastic price. I am looking f...

2018 SR3 chassis number 1156 showed up this morning from Radical Northwest. I did the Primal three day school in the SR1 at AMP in December and was hooked and had to have one. Purchased this a month l...