Rod Bender

Inspired by @kitleslie I went to check out Eagles Canyon. Great track with several sweeping corners that make the Radical come alive. Definitely more time on the table but it was a DE only weekend wit...

On my SR3 RSX, my belts look more like this: (lower part of the shoulder harnesses are 3 inch wide, all other straps are 2 inches wide) Attachment : Screen Shot 2020-11-15 at 5.50.51 AM.png

Here's a better view Attachment : IMG_1437.jpg As far as installing - not too big of a deal although there's no real guide I could find. I've seen pictures of one other SR1 with a rear diffuser...

@lunatic, If you found that in your engine I would change the oil cooler and make sure all of the lines have been flushed very well. For me it just wouldn’t be worth the risk that some more of that c...

Congratulations on getting out to the track! It is good to hear that you had good luck bringing passengers. I find that many are only good for about one lap and then they want to come in. 🙂 Charley

Take a look at the latest "Ask Phil" question where he talks about the SR3 Turbo cars and Radicals first Nürburgring record.

@rjbender, When the fuel cell starts to leak you will have a fuel smell around the car when it is in the garage. What is usually happening at this point is that there is a small (or several small ) l...

@ntf3000, Do you know what type of fuel tank his car has? It will either be an aluminum tank or a fuel cell. Also, Do you know when the situation is happening? Is it happening on left hand corners, ...

Data shows that the fuel pressure is solid. He has also replaced the fuel pressure regulator three times. There is something that resembles a fuel pump zip tied to the frame rail. Is that the regul...

I worked all week to get a new setup on the car. I went with the Hankook 'recipe' from the manual and I must say it was a good starting point. There are some things I can tweak to get some improvement...

I have heard that if one over-tightens the tie down straps, it can move the alignment or bend arms. I don't have first hand knowledge as I am new to tying down and towing, but I would rather not conf...

Okay guys...I am going through my first time setup on my 2nd gen SR3. The car came on Dunlops and I deconstructed the setup on the car as it came to me. The car was really low, lacked much camber and ...

@charleyhradicalsportscarregistry-com Thanks for the welcome! Here are some pictures of the before state, as well as some of the upgrade parts I have acquired thus far. Rich Attachment : IMG_767...

Hi everyone, I am currently completely rebuilding Prosport 117 for next spring here in Canada. As the engine builder for RPE at Radical Canada East, I have built a hybrid Gen 1 1340 dry sump, with Suz...

@davidf, Looks like a great set up! Those Race Ramps from Reverse logic really make life a lot easier. You might want to consider adding a wireless controller to the winch. The wired winches work f...