Rod Bender

G'day Josh, Looks like 45 ft.lb and then make sure the upright still movers freely (without the damper connected I guess) Attachment : Front and Rear Wishbone Torque Specs.jpeg

Hi All, I've now done 1.5 seasons of competition in my RSX, and have clocked up about 15 hours on the car (with only about 60% of this being 'on load time' due to the relatively short format 'sprint' ...

G'day Josh - I shipped mine in an 'eski' (beer cooler) and the total weight was just under 30kg's. I would expect the GDU alone to be around 24 or 25kg's?

G'day Josh, I used a scrubbing brush and some citrus cleaner (multi purpose cleaner), and then gave them a high pressure rinse with my Karcher connected to our hot water main... fantastic job - like n...

@grouparacing ... looks like it will be hard to get into/out of for most people. I'm 6' and I wouldn't exactly step over that! I wonder why the original solution they shared wasn't what went into fi...

@rojid ... sorry another question and a comment to try and help.... While trying to loosen the wheel nuts, were you or the person using the torque wrench pushing down on the wrench handle, or pulling ...

@rojid .. I'm not sure it's clear which torque wrench you were using. You mention you have a Norbar 4R above, but also mention you were borrowing an 'ordinary and shortish torque wrench'? Assuming it...

@rlm-dan - Thanks so much Dan, That will help as I would have had to drain the oil to remove the sensor and check the thread, and I'm not due for an oil change until after the next sprint event. I had...

Hi All, Wondering if anyone can help me with a couple of oil temperature and wiring loom related questions? At the last event I had some dubious oil temperature movements, that in once case on the war...

G'day Christian, I use the wheel rack in my Brian James trailer every time I go to the track. I think you have two questions; 1. How to protect the wheel/rim face? - I use a set of these covers show...

G'day Josh (@meatman) See below a thread from a week or so ago on the same/similar subject. In one of the posts I wrote up what I did to my wheels and wheel nuts that were in a similar condition to y...

@raider89 ... I switched to the 'Spin Safe'/Rekluse clutch when I put a new engine in last November. On it's third event and at this stage I wouldn't go back to the standard solution. The sprint raci...

Hi All, Just purchased the Radical kit for closed loop Lambda Control for my RSX. Before I run the cable through the engine bay I thought I would ask if anyone else had already done it, and to see ho...

@raider89 - the 40 hours is total run time - not load time, so you are right to be asking about a rebuild around this time.

@rojid ... just under 5 litres sounds about right. If I understand what you are saying you now have the swirl pot filled right to the top... completely full. That's no good. What I suggest you do is...