Rod Bender

@raider89 - Hi Dan, I haven't heard of that issue before. In fact I haven't heard or seen anything particularly special about how these pieces of hardware need to be checked so often. Probably have ...

@frank ... with the difference in front left/right locking, it will definitely be worth checking the car corner weights on a suitable flat patch if you haven't had that done recently. Radical suggest...

G’day @charleyhradicalsportscarregistry-com My new engine has arrived earlier than expected which is a nice surprise… RPE-894. Looks great and hoping to do the swap next weekend. Old Engine is complet...

G'day @dudical26 - there are some 'conical' attachment points (4 of them), one at each end of the factory 'angled sidebars'. These types of joints are typical in chassis designs, and have a bolt thro...

@tmpoquette - G'day Again Trevor. Thanks for the feedback. I don't think it's right that the oil pressure will not be below 50 psi or "don't run the engine". I suspect even in a brand new engine oil...

@dbg - final diagnosis?

@tmpoquette - Thanks Trevor, Just to be clear... this was the oil that was in the 'inlet side' of the oil filter. The oil that came out of the dry sump, etc looked really good. To get this sample I ...

@charleyhradicalsportscarregistry-com - G'day Charley Engine has just clocked up 34 hours... so probably not much to gain by taking a risk and running it too much longer. I read another thread here a...

@charleyhradicalsportscarregistry-com - G'day Charley, ... sorry to say I'll probably be needing this 'how to' in the next few weeks.... there's a lot of glittery stuff in my oil filter that I just cu...

@raider89 .. Thanks Dan - I'll give it a try. I've got to run my car soon again anyway to re-balance the throttle bodies. I'm guessing you sit in the car while doing this and use the clutch to downsh...

@raider89 ... good to know and appreciate you sharing your experience. I had been told that you should never run the car in gear while on air jacks or stands. Having seen other similar cars running i...

@raider89 - G'day Again Dan, It's great that I could at least help in a small way.... I'm no expert either, but have been using AiM gear for many years now, so I'm definitely in the 'self-taught' cate...

@raider89 - G'day Dan, Regarding your comment in this post above.... "I have gotten comfortable with the shift lights out of the corner of my eyes, just wish the manual would give the factory RPM sett...

@tmpoquette …sorry I have no idea what the light does or where the sensor is located. My 2015 RSX doesn’t have a ‘fuel light’. I’m wondering if the light is connected to a level sensor (which is what...

You won’t buy the whole valve block. I don’t think it’s supplied like that, but probably assembled by Radical (or a sub assembly supplier?) My valve block needed the normal maintenance covered elsewhe...