Rod Bender

@raider89 .. Thanks Dan - I'll give it a try. I've got to run my car soon again anyway to re-balance the throttle bodies. I'm guessing you sit in the car while doing this and use the clutch to downsh...

@raider89 ... good to know and appreciate you sharing your experience. I had been told that you should never run the car in gear while on air jacks or stands. Having seen other similar cars running i...

@raider89 - G'day Again Dan, It's great that I could at least help in a small way.... I'm no expert either, but have been using AiM gear for many years now, so I'm definitely in the 'self-taught' cate...

@raider89 - G'day Dan, Regarding your comment in this post above.... "I have gotten comfortable with the shift lights out of the corner of my eyes, just wish the manual would give the factory RPM sett...

@tmpoquette …sorry I have no idea what the light does or where the sensor is located. My 2015 RSX doesn’t have a ‘fuel light’. I’m wondering if the light is connected to a level sensor (which is what...

You won’t buy the whole valve block. I don’t think it’s supplied like that, but probably assembled by Radical (or a sub assembly supplier?) My valve block needed the normal maintenance covered elsewhe...

Well this Forum is certainly a good place to learn stuff. Seems like I’m taking my diffuser off using different approach… in my case removing the 6 x bolts that are in the vertical orientation at the ...

@johnannz … “torque monster”… sounds very different doesn’t it!… I think I would miss the sound of an RPE revving well north of 9,000rpm…..?

@johnannz … are they fully configurable to come on at different rpm’s in different gears like the MXL2 dash too?

G'day @bob, I thought I sent an earlier reply post, but now can't see it... I'll try again (apologies if it's a duplicate!) I'm not sure if the older generation SR3's are the same as the newer RSX's...

@dwang2000 ... nothing that really sounds like it does in real life. I have the recordings below. The first one is from my first ever test drive of the car while the old quiet exhaust was still on it...

@dwang2000 ... yep

G'day @dwang2000, Yes... you could try putting a little bit of 'penetrene' or WD40 into the joint first. Mine came off without that, but I had to tap it with a soft faced hammer to get it to start mo...

Yep - that's it. ....Same process as the brakes. Not related to bleeding the clutch, but for what it's worth I learned from someone that had plenty of experience, that when bleeding the brakes it pays...

@garagenwerke …. Yes. That’s the reverse gear ‘detent’ holder im not sure where you would buy one, but here’s a picture of mine when I had it out to shorten the spring. It’s actually not a ball bearin...