CharleyH .

Looking for a few other Radicals to join us on 10/12 at the Gingerman open track event. Their open events are always a blast, you never know what's going to show.

After a little digging I found a contact at PFC brakes. Darrick Dong is the contact for motorsports brakes. His phone is 803-370-0442 and email ddong@pfcbrakes.com. Darrick was super helpful and q...

Nice looking car too! 🙂

Love those photos! I'm guessing she didn't have much of a problem with helmet lift. 🙂

Good to know, must have missed that. Liking this car more and more. It's certainly the best designed and thought out that I've owned.

Radical UK sent me the wiring diagram for the carbureted SR3. Here it is, Charley feel free to upload it to the technical section. Attachment : sr3 mbe ignition and carbs..pdf

Update.....job done! Good news....the job cost nothing to do. It needed new o rings on the clutch actuator....I dug out one from some bits and pieces I already has Bad news...the job took me most of S...

I think the calipers should/might be the same SR3 to SR1 (HiSpec) assuming a newer car.. The pads I use are the PFC 01 compound p/n 7740.01.16.44, and can be purchased thru many race shops. the 08 ...

@charleyhradicalsportscarregistry-com thanks for the info. I agree with your philosophy but the quote I received from a dealer felt like more than a "slight" premium to me and thought I would shop ot...

@rlm-dan Ha!....you are probably not far wrong with the off road bit! I wanted one for a while and apart from trying to buy a new one (radical were not very responsive at the time) I found one for sal...

My guess is that the level sender is not there, just the through contacts. There is a data output from the Life ecu that tracks fuel consumption, it can be reset from the engine monitoring software. I...

There's no sensor. The original pump is from a 2002-2003 Audi TT (OEM is Siemens, I have the part number in my notebook). If you buy that pump it comes with a sensor (a swinging float) that will not ...

I live in Central Florida, and do most of my track time at Sebring (in Sebring, Florida), usually with Chin Track Days. I'll be out there in early December -- can't wait!

Hi Gareth, I remember this car from my Radical days and I seem to recall that Neil from Corinium has been working on it recently? It is a gearbox out job, so removing drive shafts etc to get to it.