Last seen: November 16, 2026 1:17 pm
Hi Dan (raider89), It was good talking with you on the phone about this. Here are a few pictures that should help you disconnect the power to the air ...
Hi Larry (@lwsr3), Unfortunately the early “Radical Dash’s” are prone to failure. You can do some troubleshooting for the sensors to make sure they a...
@raider89, One way to get them is to contact the dealer you got the car from and ask them for a copy of the build sheet which will list them all. It ...
@gwt561324, it normally doesn’t touch. You can see from the marks in the picture that the pipes normally sit higher and there is a different angle at...
Hi Dan, Yes you are doing it right. To change the engine oil remove the lower engine oil hose and allow the oil to drain. I don't know that you hav...
@lunatic, NICE!
Looks and sounds great! Thanks for the update.
(@raider89), Here is the listing of available roll bar sizes and part numbers from page 46 of the SR3XX manual. The manual is in the Resource library...
@cirrusdriver, if you already have a gurney flap you are right you need to look into better aero bits or a more aero friendly helmet. I don’t know if...
@cirrusdriver, what exhaust do you have, and what helmet do you have? The most effective way to reduce helmet lift is to add a gurney flap to the ...
I’m looking forward to seeing some dyno numbers for that monster!
@tommymills, yes, fit is the most important thing when searching for helmets. No helmet fits everyone well, so the only way to know which one is best...
I have had really good luck with Bell Helmets. My current helmet is the GP3 Carbon and I really like it. You mentioned that the Bell helmet that you...
@lunatic, you are a lucky man to have TWO road legal Radicals!