Hi David, ... so to be clear these strips (in that temperature range) are the ones you suggest using on the uprights bearing carrier? I already use t...

Hi All, I thought I would post my suspension bush question here as it’s at least related to this topic. I’ve suffered some damage from a crash abo...

@helmutweber ... there's not much 'e' about that box... mostly pneumatics in there. The 'e' part of this box contains the 3 solenoids that drive the ...

@davidf ... Great insight David. I don't know much about the TPS either.. but I do know where to buy them as I purchased a spare based on some previo...

@davidf - Thanks David, Appreciate you sharing your replies. Just checking that when you say you run “hole 3 from the bottom” on the main plane that...

Hi All, I basically have the same question that @trakmnky started this thread with, and I appreciate CharleyH's input above. I was wondering if a...

@schneller - G'day Ron, You can see the end of the shaft up the middle of the hub. I think another way around that issue would have been to use a br...

@bird - Hi Jay, Main dimensions are 40mm wide and 215mm long. The material I used is 2.5mm thick (anything between 1.5 and 3mm would work really, as...

@bird - Hi Jay, Yes. That's another thing I made and helps enormously when you are trying to maximise the use of the RPM shift lights in bright sunl...

@bird ... Hi Jay, Yes, that's something I made very early after buying my Radical and getting it up on my jack stands for the first time. I wanted a ...

@bird - Hi Jay, Radical wanted around AU$700 per set.... So we made our own from some 5/8" diameter (or 16mm) 316L stainless steel bar, and purchased...

@bird - G'day from Tasmania! Just reinstalled the rear wheels on my RSX and the Radical supplied tie-down inserts to measure this for you. 1850mm (...

@davidf … G’day David, I’ve now made some adjustable pushrods for the rear of my RSX, so now both cars have them. My setup is now ‘normally’ done usi...