Nic Hammann

Charley, Thanks again for all the help and insight! I was able to make sure when I sent the engine out all the needed parts were along. Now just waiting patiently for engine to return... As always g...

Hello, I am about to send my Radical engine off for rebuild (just engine). Already removed engine from car and boxed the engine up. However on the engine check in sheet it lists Clutch Push Rod and...

Welcome Dave! I look forward to hearing how much you like the Radical and your thoughts in comparison to the other vehicles you have owned/driven! Charley and everyone on here do such an outstanding j...

Has anyone tried Hoosiers on their Radical? I was wondering the setup changes required? I read a previous post saying low camber was needed. Any other comments/thoughts... Toe changes, tire pressure...

Jack, Glad to see you joined the Radical club! Amazing cars and I bet your smile will be as big as mine when you drive yours on track for the first time! You hit it spot on about this forum. So much i...

Last fall (November time frame) when I was prepping to put my SR3 away for the season I turned the master switch on and had a massive fuel leak. The last track event where I ran the car was in Septemb...

I finally had a chance over the weekend to change the diff oring on the left hand side of the diff and the new part I ordered from Team Stradale (P/N TQ0028) had a diameter of 2.3mm but the removed or...

@johnannz great driving! Fun watching you eat up the Porsche's and all the GT4 car's! Thanks for sharing all the videos guys!

Charley, Great post and explanation on the cables! The amount of information that is stored between the dash and ECU is awesome and is an excellent tool to become a better driver! I bought a set from ...

Thank you both for your insight and help. I will try and change the rubber o ring for the left side leak (as it is leaking on the left hand side cover) and then keep an eye on the two case halves. Pos...

At my last open track event I noticed the rear diff was leaking some fluid (very slowly) where the side cover attaches to the diff. I applied some permatex ultrablack and was able to get through the e...

Charley, Quick update, I was able to find the hydraulic brake light switch in front of the LR wheel and I think with the help of my dad pressing the pedal we were able to determine the switch is bad. ...

Charley, Thank you for the fast response! I am checking power at the chassis plug (and thanks to the wiring diagram provided under the resource library) I am not getting any power to pin 3. The pins a...

Hello, I am currently prepping my Radical SR3 for a track day and found out that I do not have any brake lights. Do the lights use a separate brake light switch (if so where is this located at)? Other...

Quick question, I apologize beforehand for the horrible picture. For the radical charger left of the driver (for LHD cars), does a person just supply 110V to the charger. Below is a picture of the And...