John Parsons

Josh, I've got a refurbished Stack dash from my 2009 SR8 with a new battery. Let me know if you have any interest. @meatman

@davidf I don't ever use SS braided hose. Only Aramid, and I use it for oil hose as well.

@tmpoquette It is actually quite common for AN rubber fuel lines to fail. Modern fuels will eat up rubber-based hose, especially ordinary AN hose. I wrote an article for Chevy Maxx magazine about this...

Hi Josh -- I'm a tinkerer too, and I agree on it being half the fun. I wanted to install a clutch actuator this past fall (my track "season" is from December to May), but I couldn't get the vendor to ...

It is a lovely car! Makes my low hoop RS-bodied SR8 look like a moving museum.

@schneller I have, using an MXS 1.2 AiM dash. I got the camera from Pegasus Racing (less than $150) and connected it to the "rear video" port on the AiM dash. I activate it with a button on my steerin...

@jwb Josh -- check with Andy. He did all his own RPx rebuilds and once told me about what timing chains he used (but I'm old and don't remember, sigh). His userid here is @captainslow. You can find hi...

I tore my suspension apart this past summer, with the intention of replacing all the bushings. After inspecting them, I couldn't find any obvious wear, so I cleaned them and put them back with some CV...

Wow. All I can be is sympathetic. I've entirely swapped out all Jenvey parts on my SR8 (at mega expense), switching to AT Power and Kinsler replacements. It took me three tries to get it all right, b...

@julian_radical Hi Julian, that looks helpful. Any chance you can send me the AiM configuration file? send to jp@unrivaledrides.com

@julian_radical I've done a lot of configuration with the MXS 1.2 dash on my 2009 SR8. I completely rewired the car and replaced the Life ECU with a MoTeC M150 ECU and replace the factory Stack dash w...

Good info, thanks! I don't own an SR3, but I've got one that comes through the shop for maintenance, and I found the Neutral/first struggle quite confusing.

Me three. It's way better than trying to get a nut started on the end of a bolt you can't see. You can put a vinyl cap on the exposed sharp edge, though my wheels are so old and "well-used" I don't wo...

@rojid Yes, that's ok. The thing not to do is to get bored and leave, then forget you were draining the tank, and come back an hour later to find the pump cavitating. Just stay there and turn off the ...

One of the racers here gave me a tip about this exact thing. Remove the upper front dive plane, leaving everything else alone. That change transformed my SR8 from a spin machine to something in which ...