m roj

I don't run cars so not the best person to answer this but personally I would be going over the car with ACF50. Its a water replant that protects from corrosion etc. The only thing to avoid with this...

@rojid Yes, that's ok. The thing not to do is to get bored and leave, then forget you were draining the tank, and come back an hour later to find the pump cavitating. Just stay there and turn off the ...

Hmm, another misprint? The factory does not safety-wire the hat to disc bolts at least on the newer cars because the bolts are fastened with a lock nut on the other side. If these were threaded into...

Update: I have all this implemented and working now. The FSW4 is an exact clone of the FSW_R radical XX wheel. The MXL2 remains as the master logger, and now emulates the PDM32's CAN output to the whe...

@rojid OK, so the standard open-end blind rivet with a dome head are what you should use. I don't know for sure the exact size but my guess is 4mm or 5/32 and probably 3mm (1/8") to 6mm (1/4") grip ...

@rojid ... just under 5 litres sounds about right. If I understand what you are saying you now have the swirl pot filled right to the top... completely full. That's no good. What I suggest you do is...

I use distilled water and 1/2 bottle of water wetter. Anti-freeze if there is a chance of freezing temperatures. Don't start the car, but turn on power. Remove water temperature sensor which will c...

@rojid, I asked one of my friends at a Radical Dealership about your issue and he told me that they have seen the issue with the starters running on until the master switch is turned off. But they sa...

m roj, Ben Jacobs has a set of pedal extensions that should help out. They came with his car and he doesn't need them. You might message him. I've also seen a few sets at Stradale if he doesn't have...

Hi @rojid, I wouldn't recommend pulling power from the second battery because you shouldn't need the unit to have power all of the time. Also, the second battery is charged by a stand alone battery c...

Brian james RT4 trailer, i tilt it and use 4x wood about 1m long each.. 2x4" and half that again so i step it up from ground. No need for advanced ramps. But BJ have their own ramps, but thet y are re...

Posted by: @rojid Would it be quite easy to repair these holes? Can i just apply some sort of fibreglass filler compound? I just removed the entire half of the fiberglass panel under the roll bar t...

@rojid "-6 AN" is the size of the fitting... not the type. As higgins613 says you will need BOTH fittings in his picture if you go that direction....

@rojid the “T-fitting” circled in green would stay. You would then remove the fitting circled in red and replace with BOTH parts in the original picture I sent. The T-fitting is NOT part of the QD. ...

In my experience: You don't have to ratchet down crazy tight If you over tighten the strap, it could bend a rod end or upright. I would much rather have my car roll back and forth a couple of inches...