Rod Bender

I would have to agree with Charley on this one. I have been using the axle tie downs. 4 points into D-rings has been plenty sufficient for my car. I've been to the track many times in this configurati...

I'm not sure I would trust those tie downs. I would feel better if they were bolted down periodically or even better if some new D rings were installed further outboard. The method I have been using...

My setup is a Featherlite 4926 20 foot bumper pull trailer which I recently acquired from the original owner who purchased it new in 2012. It is all aluminum, including the flooring which is extruded...

Reading through Hayabusa forums people point to a fuel pump/filter for this issue. I guess no harm in replacing it to rule that out. It stinks though that there's no way to really test it besides payi...

Forum Member John Annunziata, contacted me recommending that we create a new Forum Section for Track and Race Videos. I think that is a fantastic idea (and wish I thought of it myself). So when you ...

I run the Sunoco GT 260 here in the US in mine. That or VP 100 seems to be the fuel of choice.

@rjbender I have ~1" of splitter clearance at the front (see pics above), absolutely NWIH it'll go up forwards. It scrapes a bit going backwards, but I could probably jack the trailer a bit more and a...

For my SR3 I always use 100 octain Racing fuel. Usually VP Racing fuel. SR8’s use the same. Charley

one thing to remember is that with one of the axle circuits open (front or back) the master cylinder for that circuit will travel much farther than the other, and possibly bind the bias adjuster. I us...

I knew someone would see that! its just sitting there drying after cleaning, since I had a blower pointed at the rad inlet earlier. It does not live there.

@CharleyH Thanks! Yeah, unfortunate and deemed as a racing incident, which, well, I'm not too happy about. @Rjbender It's captured with a GoPro Hero 8, and it just uses the standard Go Pro slide-in m...

@gobble, Can you post a picture of the top of the plate to better show the pneumatic solenoid and another picture of the actuator? The reason I am asking is it looks a bit different from the parts I ...

Replied 😀

Hi Jase (@jase), My car has been sitting for over a month so the tank pressure should have been ~0. I turned on the power and it took about 45 seconds until it shut off. Have you checked for air lea...

Those ramps look great Rod. Tanks for sharing. Charley